All4Certs Cisco Archive,Exam Archive CertBus Cisco 400-101 the Most Up to Date VCE And PDF Instant Download

CertBus Cisco 400-101 the Most Up to Date VCE And PDF Instant Download

CCIE 400-101 easy pass guidance: Preparing for Cisco CCIE 400-101 exam is really a tough task to achieve. However, CertBus provides the most comprehensive PDF and VCEs, covering each knowledge points required in the actual 400-101 exam.

We CertBus has our own expert team. They selected and published the latest 400-101 preparation materials from Cisco Official Exam-Center: http://www.certgod.com/400-101.html

QUESTION NO:4

A TCP/IP host is able to transmit small amounts of data (typically less than 1500 bytes), but attempts to transmit larger amounts of data hang and then time out. What is the cause of this problem?

A. A link is flapping between two intermediate devices.

B. The processor of an intermediate router is averaging 90 percent utilization.

C. A port on the switch that is connected to the TCP/IP host is duplicating traffic and sending it to a port that has a sniffer attached.

D. There is a PMTUD failure in the network path.

Answer: D


QUESTION NO:13

Refer to the exhibit.

While troubleshooting high CPU utilization of a Cisco Catalyst 4500 Series Switch, you notice the error message that is shown in the exhibit in the log file.

What can be the cause of this issue, and how can it be prevented?

A. The hardware routing table is full. Redistribute from BGP into IGP.

B. The software routing table is full. Redistribute from BGP into IGP.

C. The hardware routing table is full. Reduce the number of routes in the routing table.

D. The software routing table is full. Reduce the number of routes in the routing table.

Answer: C


QUESTION NO:14

Refer to the exhibit.

All switches have default bridge priorities, and originate BPDUs with MAC addresses as indicated. The numbers shown are STP link metrics. Which two ports are forwarding traffic after STP converges? (Choose two.)

A. The port connecting switch SWD with switch SWE

B. The port connecting switch SWG with switch SWF

C. The port connecting switch SWC with switch SWE

D. The port connecting switch SWB with switch SWC

Answer: C,D


QUESTION NO:16

Refer to the exhibit.

If a port is configured as shown and receives an untagged frame, of which VLAN will the untagged frame be a member?

A. VLAN 1

B. VLAN 2

C. VLAN 3

D. VLAN 4

Answer: B


QUESTION NO:11

Refer to the exhibit.

Which action will solve the error state of this interface when connecting a host behind a Cisco IP phone?

A. Configure dot1x-port control auto on this interface

B. Enable errdisable recovery for security violation errors

C. Enable port security on this interface

D. Configure multidomain authentication on this interface

Answer: D


QUESTION NO:6

Refer to the exhibit.

Which statement is true?

A. It is impossible for the destination interface to equal the source interface.

B. NAT on a stick is performed on interface Et0/0.

C. There is a potential routing loop.

D. This output represents a UDP flow or a TCP flow.

Answer: C


QUESTION NO:3

Which two options are causes of out-of-order packets? (Choose two.)

A. a routing loop

B. a router in the packet flow path that is intermittently dropping packets

C. high latency

D. packets in a flow traversing multiple paths through the network

E. some packets in a flow being process-switched and others being interrupt-switched on a transit router

Answer: D,E


QUESTION NO:17

Refer to the exhibit.

Which statement describes the effect on the network if FastEthernet0/1 goes down temporarily?

A. FastEthernet0/2 forwards traffic only until FastEthernet0/1 comes back up.

B. FastEthernet0/2 stops forwarding traffic until FastEthernet0/1 comes back up.

C. FastEthernet0/2 forwards traffic indefinitely.

D. FastEthernet0/1 goes into standby.

Answer: C


QUESTION NO:10

Which type of port would have root guard enabled on it?

A. A root port

B. An alternate port

C. A blocked port

D. A designated port

Answer: D


QUESTION NO:18

Refer to the exhibit.

Which technology does the use of bi-directional BPDUs on all ports in the topology support?

A. RSTP

B. MST

C. Bridge Assurance

D. Loop Guard

E. Root Guard

F. UDLD

Answer: C


CertBus exam braindumps are pass guaranteed. We guarantee your pass for the 400-101 exam successfully with our Cisco materials. CertBus CCIE Routing and Switching Written v5.0 exam PDF and VCE are the latest and most accurate. We have the best Cisco in our team to make sure CertBus CCIE Routing and Switching Written v5.0 exam questions and answers are the most valid. CertBus exam CCIE Routing and Switching Written v5.0 exam dumps will help you to be the Cisco specialist, clear your 400-101 exam and get the final success.

400-101 Latest questions and answers on Google Drive(100% Free Download): https://drive.google.com/file/d/0B_3QX8HGRR1mdEpkTFZvSDJDc2c/view?usp=sharing

400-101 Cisco exam dumps (100% Pass Guaranteed) from CertBus: http://www.certgod.com/400-101.html [100% Exam Pass Guaranteed]

Why select/choose CertBus?

Millions of interested professionals can touch the destination of success in exams by certgod.com. products which would be available, affordable, updated and of really best quality to overcome the difficulties of any course outlines. Questions and Answers material is updated in highly outclass manner on regular basis and material is released periodically and is available in testing centers with whom we are maintaining our relationship to get latest material.

BrandCertbusTestkingPass4sureActualtestsOthers
Price$45.99$124.99$125.99$189$69.99-99.99
Up-to-Date Dumps
Free 365 Days Update
Real Questions
Printable PDF
Test Engine
One Time Purchase
Instant Download
Unlimited Install
100% Pass Guarantee
100% Money Back
Secure Payment
Privacy Protection