One of my colleague recommend me that CertBus 642-427 dumps are effective and helpful. Thank goodness I followed up with him and choose CertBus as my assistance on my 642-427 Troubleshooting Cisco Unified Communications v8.0 (TVOICE v8.0) certification exam! I passed my Cisco 642-427 exam very easily. I was lucky, all my questions in the exams were from my Cisco 642-427 dumps.
We CertBus has our own expert team. They selected and published the latest 642-427 preparation materials from Cisco Official Exam-Center: http://www.certgod.com/642-427.html
QUESTION NO:11
Refer to the exhibits.
MOH has been configured to run from flash at the BR1 site. The HQ phones and MOH server are placed in the Default region through the Default device pool. The BR1 phones are placed in the BR1 region through the BR1 device pool. The region configuration between Default and BR1 only permits G.729 codec.
When an IP phone user at the HQ site places a BR1 caller on hold, the BR1 caller hears tone on hold. Which of the following can cause this issue?
A. Multicast routing is not enabled on the BR1 router.
B. The command ip pim separate-dense-mode is missing from interface VLAN 120 at the SRST router in BR1.
C. The MOH server is unable to stream MOH using G.711 codec because of the regions configuration.
D. The command route 10.1.120.1 must be added to the multicast moh 239.1.1.1 port 16384 command at the SRST router in BR1.
E. The Max Hops is too small in the MOH configuration
Answer: B
Explanation: Explanation-The router runs IP Multicast routing and IP PIM sparse-dense mode on any physical interface that must participate in multicast (PIM is in either sparse or dense mode, but the interface can be configured to forward sparse mode, dense mode, or both).
Link-
http://www.cisco.com/en/US/technologies/tk436/tk428/technologies_white_paper0900aecd801312 81_ns465_Networking_Solutions_White_Paper.html
QUESTION NO:14
Refer to the exhibit.
Refer to the exhibit. The exhibit shows the output of debug isdn q931. An inbound PSTN call was received by a SIP gateway that is reachable via a SIP trunk that is configured in Cisco Unified Communications Manager. The call failed to ring extension 3001. If the phone at extension 3001 is registered and reachable through the gateway inbound CSS, which three actions can resolve this issue? (Choose three.)
A. Change the significant digits for inbound calls to 4 on the SIP trunk configuration in Cisco Unified Communications Manager.
B. Configure the digit strip 4 on the SIP trunk under Incoming Called Party Settings in Cisco Unified Communications Manager.
C. Configure a translation pattern in Cisco Unified Communications Manager that can be accessed by the trunk CSS to truncate the called number to four digits.
D. Configure a called-party transformation CSS on the gateway in Cisco Unified Communications Manager that includes a pattern that transforms the number from ten digits to four digits.
E. Configure a voice translation profile in the SIP Cisco IOS gateway with a voice translation rule
that truncates the number from ten digits to four digits.
F. Configure the Cisco IOS command num-exp 2288223001 3001 on the gateway ISDN interface.
Answer: A,C,E Explanation:
QUESTION NO:7
Refer to the exhibit.
When a Cisco IP Communicator phone roams from San Jose (SJ) to RTP, the Cisco IP Communicator physical location and the device mobility group change from SJ to RTP All route patterns are assigned a route list that points to the local route group All device pools are configured to use the local route group Which statement is true when the roaming phone places an AAR call?
A. Since globalized call routing is not configured, then the SJ gateway will be used in this case
B. The phone will use the AAR CSS that contains the SJ_PSTN partition. The call will egress at the SJ gateway
C. The phone will use the AAR CSS that contains the RTP_PSTN partition. The call will egress at the SJ gateway
D. The phone will use the AAR CSS that contains the SJ_PSTN partition. The call will egress at the RTP gateway.
E. The phone will use the AAR CSS that contains the RTP_PSTN partition The call will egress at the RTP gateway
Answer: D Explanation:
Cisco Unified Communications Manager Version 7.0 introduced the Local Route Group feature. When using local route groups, gateway selection is totally independent of the matched route pattern and referenced route list and routegroup. The use of the Local Route Group feature makes no changes regarding roaming-sensitive settings. The application of these settings always makes sense when roaming between sites. The settings have no influence to the gateway selection and the dial rules that a user must follow. However, the dial planrelated part of Device Mobility changes substantially withthe new dial plan concept, This concept allows a roaming user to follow the home dial rules for external calls but use the local gateway of the roaming site In this case, When the device mobility group is not the same for San Jose and RTP, the Device Mobility related settings are not applied. The phone device keeps its San Jose-specific configuration Despite the San Jose-specific configuration on the phone, the PSTN calls that originate from the roaming phone are routed via the local PSTN gateway (RTP GW) and are based on the route list and device pool local route group settings. The San Jose-specific dial plan is used. Also, AAR remains configured with the San Jose-specific configuration, but if the San Jose dial plan and San Jose AAR CSS permit and if the AAR group contains the prefix that can be applied in RTP, then AAR can work
QUESTION NO:5
When a database replication issue is suspected, which three tools can be used to check the database replication status? (Choose three.)
A. Cisco Unified Communications Manager RTMT tool
B. Cisco Unified Communications Manager Serviceability interface
C. Cisco Unified Reporting
D. Cisco Unified Communications Manager CLI interface
E. Cisco IP Phone Device Stats from the Settings button
F. Cisco Unified OS Administration interface
Answer: A,C,D Explanation: Link-
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00809643e8.
shtml
QUESTION NO:8
Refer to the exhibits.
Low latency queuing has been implemented on the HO and BR1 routers to allow five G.729 calls. Callers are still experiencing poor audio, in particular choppy and delayed audio during traffic congestion. This problem occurs even with just one active call.
Which two actions will solve the issue?
A. Change the codec type to G 711. J
B. Configure RSVP call admission control
C. Configure L ink Fragmentation and Interleave on the WAN links
D. Configure RTP header compression on the WAN links
E. Increase the priority queue bandwidth to 80 Kb/s
F. Configure location settings in Cisco Unified Communications Manager to 1 20 Kb/s
Answer: C,D
Explanation: Explanation-below link is very good to understand this concept.
Link-http://www.cisco.com/en/US/docs/ios/12_2/qos/configuration/guide/qcflem.html
QUESTION NO:3
Which statement about device mobility is true?
A. When local route groups are used, there is no need to conjure device mobility groups or phone device CSSs as long as phone line CSSs are used.
B. When local route groups are used, you must configure device mobility groups and phone device CSSs.
C. When the device mobility group at the home device pool and roaming device pool are not the same, the Phone will keep the home region.
D. When device mobility groups at the home device pool and roaming device pool are the same, the phone will keep the home MRGL setting.
Answer: A Explanation:
QUESTION NO:16
Refer to the exhibit. Assume a centralized Cisco Unified Communications Manager topology with the headquarters at RTP and remote located at the U.K. All route patterns are assigned a route list that contains a route group pointing to the local gateway. RTP route patterns use the RTP gateway, and U.K. route patterns use the U.K. gateway.
When a U.K. user logs into an RTP phone using the Cisco Extension Mobility feature and places an emergency call to 0000, which statement about the emergency call is true?
A. The call will match the U.K_Emergency route pattern partition and will egress at the RTP gateway.
B. The call will match the U.K_Emergency route pattern partition and will egress at the U.K. gateway.
C. The call will match the RTP_Emergency route pattern partition and will egress at the RTP gateway.
D. The call will match the RTP_Emergency route pattern partition and will egress at the U.K. gateway.
E. The call will fail.
Answer: B Explanation:
QUESTION NO:4
Refer to the SDI trace in the exhibit A PSTN call arrived at the MGCP gateway that is shown in the SDI trace. If the caller ID that is displayed on the IP phone is 087071 222 and the HQ_clng pty_CSS contains the HQ_cing_pty_Pt partition, which exhibit shows the correct gateway digit manipulation”?
A. Exhibit A
B. Exhibit B
C. Exhibit C
D. Exhibit D
Answer: D Explanation: Explanation-Actual incoming number is 14-087071 222 but next to this information in trace we can see two digits are stripped which is international code hence D is valid answer.
QUESTION NO:22
Refer to the exhibit.
An intercluster call was placed from extension 2001 to 3001. The SDI trace from the calling cluster. Which RTP port was used by the calling phone?
A. 4000
B. 8000
C. 18462
D. 19470
E. Not possible to tell because a second invite was sent because of call failure
Answer: C
Explanation: Explanation- RTP port shows in the logs.
QUESTION NO:15
Which of these is used by the Cisco IP phone to relay to the switch the information regarding how much power is needed?
A. the Cisco Discovery Protocol
B. IEEE 802.10 protocol
C. Cisco IP phones always use a fixed power consumption hased on the resistor, which is specific to the model
D. The switch model determines how much power is consumed by the different phone models
Answer: A Explanation: Explanation-if CDP is enabled on the switch, 15.4W is initially allocated, and then further refined when the CDP message is received from the PD
Link-
http://www.cisco.com/en/US/products/hw/phones/ps379/products_qanda_item09186a00808996f3. shtml
CertBus exam braindumps are pass guaranteed. We guarantee your pass for the 642-427 exam successfully with our Cisco materials. CertBus Troubleshooting Cisco Unified Communications v8.0 (TVOICE v8.0) exam PDF and VCE are the latest and most accurate. We have the best Cisco in our team to make sure CertBus Troubleshooting Cisco Unified Communications v8.0 (TVOICE v8.0) exam questions and answers are the most valid. CertBus exam Troubleshooting Cisco Unified Communications v8.0 (TVOICE v8.0) exam dumps will help you to be the Cisco specialist, clear your 642-427 exam and get the final success.
642-427 Latest questions and answers on Google Drive(100% Free Download): https://drive.google.com/file/d/0B_3QX8HGRR1mcmhuYmRGWV84cDQ/view?usp=sharing
642-427 Cisco exam dumps (100% Pass Guaranteed) from CertBus: http://www.certgod.com/642-427.html [100% Exam Pass Guaranteed]
Why select/choose CertBus?
Millions of interested professionals can touch the destination of success in exams by certgod.com. products which would be available, affordable, updated and of really best quality to overcome the difficulties of any course outlines. Questions and Answers material is updated in highly outclass manner on regular basis and material is released periodically and is available in testing centers with whom we are maintaining our relationship to get latest material.