Latest CertBus HP0-780 Exam HP0-780 Dumps 100% Free Download

HP0-780 easy pass guidance: Preparing for Cisco HP0-780 exam is really a tough task to achieve. However, CertBus provides the most comprehensive PDF and VCEs, covering each knowledge points required in the actual HP0-780 exam.

We CertBus has our own expert team. They selected and published the latest HP0-780 preparation materials from HP Official Exam-Center: http://www.certgod.com/HP0-780.html

QUESTION NO: 214

The storage pool on tape has used a large number of volumes during the last few days. Which

approach would find the node which uses the largest amount of tape?

A. analyze the hardware log for hardware errors

B. analyze the q occupancy output for the largest data consumer

C. analyze the q volume usage output to determine the largest volume consumer

D. check the activity log for the largest tape requester/consumer or hardware problem

Answer: B

QUESTION NO:49

An administrator has a new, local, IP-based printer that is not communicating with the system. Ping is successful using the printer IP address and the printer name, and response time is acceptable. Users can print from Windows.

What should the administrator do next to troubleshoot the printer?

A. Verify that there is a route configured to the printer.

B. Use the TRACEROUTE command to find where the connection fails.

C. Verify that the printer address is correcting the HOSTS table on the system.

D. Display the printer device description to confirm that the correct port has been configured.

Correct Answer: D

QUESTION NO: 62

Which command can only be used with the manual installation for the Windows TSM server?

A. db2start

B. db2 updatedbm cfg using dftdbpath f:

C. db2icrt -a SERVER -u tsminst1tsminst1

D. db2 updatedbm cfg using dftdbpath /home/tsminst1

Answer: B

QUESTION NO: 145

An LPAR requires more disk space so an application logging filesystem in datavg can be extended.

There is an unused LUN, hdisk5, on the VIO Server.

Which command (or commands) will map the drive directly to the client?

A. mkvdev-vdev hdisk5 -vadaptervhost3 -devtest1_disk5

B. mkvdev-vdevvhost3-devhdisk5-vadaptertest1_disk5

C. extendvg datavg hdisk5 mklv-lv testl _disk5 datavg mkvdev -vdev testl _di sk5 -vadapter vhost3

D. extendvg datavg hdisk5mkvdev -vdev hdisk5 -vadapter vhost3 mklv -Iv testl disks -vdev vhost3

Correct Answer: A

QUESTION NO:136

Programmers working on a software development project frequently need to save their development library (LIBX) at the prior release level of the operating system.

The administrator needs to change the default value of the SAVLIB command parameter to accommodate the programmers” prior release save requirement.

The default value before the change was: SAVLIB LIB(LIBX) TGTRLS(*CURRENT) The default value after the change will be: SAVLIB LIB(LIBX) TGTRLS(*PRV)

What should the administrator do to facilitate the change?

A. Adjust the system value QFRCCVNRST (Force conversion on restore) to *PRV.

B. Use the Change Command Default (CHGCMDDFT) command to change the TGTRLS parameter value to *PRV.

C. Use the Save Restore Configuration (SAVRSTCFG) command to change the TGTRLS parameter value to *PRV.

D. Use the command WRKREGINF to modify the exit point program QIBM_SAV_SECURITY and change the TGTRLS parameter value to *PRV.

Correct Answer: B