CertBus New Updated HP0-Y32 Exam Dumps Free Download

Do not worry about your HP0-Y32 exam preparation? Hand over your problems to CertBus in change of the HP0-Y32 Design and Troubleshooting Open Standard Networks certifications! CertBus provides the latest HP HP0-Y32 exam preparation materials with PDF and VCEs. We CertBus guarantees you passing HP0-Y32 exam for sure.

We CertBus has our own expert team. They selected and published the latest HP0-Y32 preparation materials from HP Official Exam-Center: http://www.certgod.com/HP0-Y32.html

QUESTION NO: 9

Click the Exhibit button.

Two HP A-Series Routers are connected together. The route for 10.10.10.10/32 does not show up in

Router #1. Why?

A. Router 2 must be in Area 0.

B. Area 2 is a stub area and cannot redistribute routes.

C. Loopback interfaces cannot be announced by OSPF.

D. There is a mismatch in the OSPF process IDs.

Correct Answer: B

QUESTION NO: 11

Some clients in VLAN1 have periodic problems pinging clients in VLAN2 and vice versa. The ping failure

can last up to 10 minutes before it corrects itself. The clients in VLAN1 can still ping all the clients in their

own VLAN, but cannot reach the Internet or ping clients in VLAN2. Clients in VLAN2 can reach the

Internet.

1

Based on these basic facts, what can you “rule out” as possible causes of this problem? (Select Three)

A. The external gateway having no route to VLAN 2.

B. Miconfigured clients in VLAN1

C. A transient layer 1 issue

D. The firewall enabled on the client causing connectivity issues.

E. A loop in VLAN1

Correct Answer: ACD

QUESTION NO: 7

You choose to configure Intelligent Resilient Framework (IRF) on your two HP A-Series switches. Which

advantages does this feature offer? (Select three.)

A. IRF can use a track to bind a priority reduction to connectivity to an ISP router, providing intelligent

selection of the master.

B. IRF enables the switches to share a virtual IP address and maintain their own IP addresses as well.

C. IRF provides authentication to prevent unauthorized devices from becoming part of the group.

1

D. IRF provides failover for Network Address Translation (NAT) sessions.

E. IRF offers full load balancing for Layer 2 and Layer 3 traffic on link aggregations that can span both

switches.

Correct Answer: CDE

QUESTION NO: 5

Using Intelligent Resilient Framework (IRF), you configure two switches to act as a single switch for

reasons of resiliency and capacity. You install a cable between the devices connecting their IRF ports.

However, the virtual IRF device is still not working. You verify the cable and the physical ports, but cannot

get the devices to function. What are possible reasons why the virtual device not working?

A. The IRF devices do not have unique Member IDs.

B. The fabric names are the same within the IRF fabric.

C. IRF active command has not been executed.

D. The devices are running the same major revision of firmware, but different minor revisions.

Correct Answer: C

QUESTION NO: 2

Click the Exhibit button.

1

A user adds an untagged link between switch 20c and 30b. What is the impact of the user’s actions?

A. Internet connectivity to subnet 20 users is broken.

B. STP Root Bridge of Subnet 20 moves.

C. All Subnet 20 traffic is routed through Subnet 30.

D. STP alternate path selection remains unchanged.

Correct Answer: B

QUESTION NO: 6

On an HP A-Series router, you have configured dynamic Network Address Translation (NAT) for IP

addresses in the 10.1.0.0/20 range. You have also configured static NAT to permit outside users to

connect to various services in the 10.1.14.0/24 subnet. You have also applied a connection limit policy with

this rule:limit 0 acl 3001 per-destination amount 800 100ACL 3001 selects 10.1.14.0/24 destination

addresses.What is the function of the connection limit policy?

A. Devices within the 10.1.14.0/24 are allowed to establish between 100 and 800 connections. Other

devices in the 10.1.0.0/20 range are banned from NAT.

B. Devices within the 10.1.14.0/24 are allowed to establish between 100 and 800 connections. Other

devices in the 10.1.0.0/20 range have NAT applied to them with no limit.

C. Outside devices are allowed to make only 100 to 800 connections to devices in the 10.1.14.0/24 range.

No limit applies to other devices in the 10.1.0.0/20 range.

D. Outside devices are allowed to make only 100 to 800 connections to devices in the 10.1.14.0/24 range.

They cannot make connections to other devices in the 10.1.0.0/20 range.

Correct Answer: C

QUESTION NO: 4

You are configuring a link aggregation between an HP E-5400 zl Series switch at the access layer and a

Cisco switch at the aggregation layer. What is one valid reason for using static LACP instead of dynamic

LACP?

A. Cisco’s implementation of dynamic LACP is not industry standard.

B. Cisco switches transmit dynamic LACP frames as tagged in the link aggregation’s native VLAN, but HP

E-Series switches expect untagged frames.

C. HP E-Series switch link aggregations can only receive VLAN assignments through GVRP when they

implement dynamic LACP.

D. HP E-Series switches require one side of a dynamic LACP link to operate in passive mode, but Cisco

switches support only active mode for dynamic LACP.

Correct Answer: C

QUESTION NO: 10

Which statements are true about MSTP? (Select two.)

1

A. MSTP is backward compatible with RSTP and STP.

B. MSTP BPDUs can only be transported in VLAN 1.

C. MSTP BPDUs are untagged.

D. MSTP BPDUs are untagged in untagged VLANs and tagged in tagged VLANs.

E. MSTP BPDUs cannot be sent if VLAN 1 is not enabled.

Correct Answer: AC

QUESTION NO: 8

Your LAN uses a private network addressing scheme, and you own a single public IP address that all

devices share on the Internet. How do you configure Network Address Translation (NAT) on an HP A-

Series router to support this implementation?

A. Select the private IP addresses in an ACL and apply outbound NAT to the ACL on the router’s Internet-

facing interface.

B. Configure a server NAT policy that selects the private IP addresses and associates them with an

outbound interface.

C. Create two ACLs, one with the private IP addresses and one with the public IP address. Associate the

ACLs in a global many-to-one NAT policy.

D. Select the private IP addresses in an ACL and apply source NAT to the ACL on the router’s LAN-

facing interface.

Correct Answer: A

QUESTION NO: 1

Click the Exhibit button.

You install two E5400 zl Series switches and connect them with a two-port static trunk. All hosts on both

switches are in VLAN 20. However, some hosts on Core 1 cannot ping some hosts on Core 2 and vice

versa. All hosts can ping all hosts on their own switch. Event logs on the two switches do not show

significant errors.What should you do to determine the cause of this connectivity issue? (Select three.)

A. Use traceroute to determine which device is dropping the ping packets.

B. Verify the trunk configuration on each core switch.

C. Change the IP address for the default VLAN on Core 2 so that it is in the same subnet as the default

VLAN on Core 1.

D. Verify physical connectivity between the switches.

E. Use LLDP to check the identities of the devices and their neighbors.

Correct Answer: BDE

CertBus exam braindumps are pass guaranteed. We guarantee your pass for the HP0-Y32 exam successfully with our HP materials. CertBus Design and Troubleshooting Open Standard Networks exam PDF and VCE are the latest and most accurate. We have the best HP in our team to make sure CertBus Design and Troubleshooting Open Standard Networks exam questions and answers are the most valid. CertBus exam Design and Troubleshooting Open Standard Networks exam dumps will help you to be the HP specialist, clear your HP0-Y32 exam and get the final success.

HP0-Y32 Latest questions and answers on Google Drive(100% Free Download): https://drive.google.com/file/d/0B_3QX8HGRR1mN19SZGR2aU1yTlU/view?usp=sharing

HP0-Y32 HP exam dumps (100% Pass Guaranteed) from CertBus: http://www.certgod.com/HP0-Y32.html [100% Exam Pass Guaranteed]

Why select/choose CertBus?

Millions of interested professionals can touch the destination of success in exams by certgod.com. products which would be available, affordable, updated and of really best quality to overcome the difficulties of any course outlines. Questions and Answers material is updated in highly outclass manner on regular basis and material is released periodically and is available in testing centers with whom we are maintaining our relationship to get latest material.

Brand	Certbus	Testking	Pass4sure	Actualtests	Others
Price	$45.99	$124.99	$125.99	$189	$69.99-99.99
Up-to-Date Dumps
Free 365 Days Update
Real Questions
Printable PDF
Test Engine
One Time Purchase
Instant Download
Unlimited Install
100% Pass Guarantee
100% Money Back
Secure Payment
Privacy Protection