[PDF and VCE] Free Share 000-N04 PDF Exam Preparation Materials with CertBus Real Exam Questions

Do not worry about that if you are stuck in the 000-N04 exam difficulties, CertBus will assist you all your way through the 000-N04 IBM Commerce Solutions Order Mgmt Technical Mastery Test v1 exam with the most update 000-N04 PDF and VCE dumps. CertBus exam 000-N04 preparation materials are the most comprehensive material, covering every key knowledge of 000-N04 IBM Commerce Solutions Order Mgmt Technical Mastery Test v1 exam.

We CertBus has our own expert team. They selected and published the latest 000-N04 preparation materials from IBM Official Exam-Center: http://www.certgod.com/000-N04.html

QUESTION NO:23

Which command will help an administrator to find the IBM i Navigator jobs?

A. WRKJOB TYPE(*PJ)

B. WRKJOB JOB(QZRCSRVS)

C. WPKACTJOB JOB(*REMOTE)

D. WRKUSRJOB USER(*CENTRAL)

Correct Answer: B

QUESTION NO: 61

The administrator of a Power 740 is attempting to define an IVE port as promiscuous for a new VIO server.

All LPARs using the IVE port have been shut down, but the administrator still receives a message stating

that the VIO server cannot be designated as the promiscuous LPAR. What steps can be performed to

enable the IVE port as promiscuous for the VIO server?

A. Power off the Managed System and reactivate it.

B. Remove the IVE configuration from the existing LPARs and reactivate them.

C. Set the promiscuous setting to “none” and save the setting before attempting the operation again.

D. Change the MCS value from 16 to a lower value.

Correct Answer: B

QUESTION NO:143

An administrator needs to set up and configure a monitor for disk usage under Management Central. Monitors, Based on the image shown, which option is used to set up this monitor?

A. Job

B. File

C. System

D. Message

Correct Answer: C

QUESTION NO:132

When installing the Group HIPER PTE5 (SE99709 for IBM i 7.1), the administrator discovered that only the first PTE on the DVD was installed. What is the most likely reason this occurred?

A. The incorrect option on the PTE menu was used to install the PTFs.

B. The platform was IPLed from the “P” side1 instead of from the “T” side.

C. A firmware upgrade was not performed prior to installing the Group HIPER.

D. The system was IPLed from the “A” side, and needed to be IPLed from the “B” side.

Correct Answer: A

QUESTION NO:24

The XML spec constrains the valid values for an ID attribute. Which of the following is FALSE?

A. ID attribute value cannot begin with and contain any whitespace.

B. ID attribute value cannot begin with a number.

C. ID attribute value cannot match the value of an existing IDREF attribute value.

D. ID attribute value has to be unique throughout the whole XML document.

Answer: C